A few steps from here to home.
Start with your account and a computer or Raspberry Pi that can stay on your device network.
1. Sign in to Eddy
Create an account, confirm your email, then sign in. Your rooms, controllers and devices live in your Eddy account.
Sign in2. Install Eddy Bridge Agent
Get the Windows, Mac or Raspberry Pi installer from Bridge Downloads. Run it on the device that will connect to your local controllers.
Get the installer3. Link your bridge
Open local Eddy Setup and follow the account-linking instructions. Use the verification address and code shown there, then enable the integrations you want.
Link a bridge4. Add a controller
In Controllers, choose your room and controller type. Follow discovery or enter the connection details requested. Some devices show an approval prompt or PIN.
Open Controllers5. Test and map your controls
Test a simple command in Eddy first. Check Virtual Devices and use Guided setup to map the available power, playback, input and volume commands.
Open Guided setup6. Set up voice control
Open the smart home integration you want to use. Select supported controls and complete that integration’s linking or pairing steps.
Connect your smart homeTell us about your device and the step you’re on.